Heat Tech VEST Benutzerhandbuch Seite 9

PICT. 3
i. Inside the control screen you have the option to set the temperature (heating power) by sliding over the
circle controller or by pressing the "+" and "-" button
j. The battery icon in the centre reports the remaining heating capacity The Vest is ready for use.
k. Alternatively for longer heating effect during riding, connect the vest directly to motorcycle cigarette port.
To do this, use the motorcycle cigarette cable adaptor (11), connecting cable DC port (13) to vest DC plug (8)
inside the vest battery pocket (5), and the cable DIN Hella plug (12) to motorcycle cigarette port.
6.3 Activation
Alpinestars HT HEAT TECH Vest can be activated and controlled by different means:
1. Manual control
a. Activation: press the LED control button (4) for three seconds to turn the power ON. The LED will illuminate
with the RED (high heating) level. At this point adjust the temperature to the desired setting.
b. Temperature Adjustment: to select or change the desired internal heat setting, press the LED control
button (4) on the lower right frontal edge of the Vest until the desired heating color level is reached. LED
colors have the following meanings:
RED = HIGH HEATING
ORANGE = MEDIUM HEATING
YELLOW = LOW HEATING
IMPORTANT!
To enable the Vest to function suitably in cold weather and subject to conditions such
as the external weather/ambient environment and the riding speed, the heating tem-
perature that the Vest may reach on the RED High Heating level can be as high as 60°C/
140°F. Accordingly, use the Vest only in the pre-defined conditions and adjust the heating
level to the heating level appropriate to you and one that will not cause you discomfort
or distraction while riding. If while riding you become aware that the heating level is
creating discomfort, stop your ride and adjust the heating level.If discomfort continues,
switch the Vest off.
8 EN
g. Once connected, click on the tool icon
to allow the access to the Alpinestars
Heat Tech App's system management
screen. Clicking on the bin icon, you can
delete and disconnect your item from
the App (ref. App picture 3).
h. To enable or disable the automatic
Vest control, please pull the slider to the
"ON" or "OFF" direction (ref. App
picture 4).
PICT. 4