Assembly And Connection; Installation - Ecolab Smartpower Rinse Dispenser Bedienungsanleitung

5

Assembly and connection

CAUTION!
– Assembly must always be carried out by authorised personnel using these
operating instructions.
– Wear appropriate protective clothing during the assembly and handling of
this system. All valid safety regulations on handling chemicals must be
observed.
– Electrical work must only be carried out by qualified electricians. Opening
covers or removing parts may expose other parts carrying an electrical
current. Connection points may also be live.
– Always use approved installation parts and accessories; refer to the
accessories and installation list.
– Make absolutely sure that all line connections are firmly mounted and
leakproof.
– Improper assembly may lead to injury due to chemical leaks.
– Legal regulations and the applicable product data sheets (
sheets' on page 20 ) must be taken into account for all chemicals.
– Wear personal protective equipment.
5.1

Installation

Installation site
The SMARTPOWER
EcoPlus PDRX.
When determining the installation site, make sure the specifications of the unit are
adhered to. The unit must not be exposed to strong shocks or constant vibrations.
Electromagnetic fields e.g. by motors or transformers, must be avoided.
Direct heat, especially direct sunlight, will heat up the unit inside the housing and can
damage the unit. Make sure the unit is not exposed to direct sunlight.
Before installation, make sure the supply lines are properly connected.
Ä Chapter 10 'Technical data' on page 61 .
Wall condition
When mounting the compontent on a wall, it must be ensured that the wall can support
the weight on a permanent basis (see
Climatic conditions
The ambient temperature and relative humidity at the installation site must correspond to
the technical data.
Mounting position
The unit should be wall-mounted upright.
TM Rinse Dispenser is mounted in the immediate vicinity of the
Ä Chapter 10 'Technical data' on page 61 ).
Ä Chapter 10 'Technical data' on page 61
25
Assembly and connection
Ä
'Safety data
MAN054125 Ver. 01-04.2024