Set-Up / Functional Description - Ecolab Smartpower Rinse Dispenser Bedienungsanleitung

4

Set-up / Functional description

Design SMARTPOWER
Fig. 1: Design
Cover with sensor
1
Product cylinder with product feed
2
Front flap
3
Infrared sensor
4
Solenoid valve
5
Drip tray
6
Function description
The SMARTPOWER
rinse aid products. It essentially consists of a base ( Fig. 1 ,
with product feed
system separator
and concentration consistency, the clean water can be dispensed in pulse mode with a
Rinse-Pulse-Timer board
The Rinse-Pulse-Timer board is disabled by default.
After opening the front flap
freely accessible for assembly, maintenance and repair.
The SMARTPOWER
controlled via the WWC-PCB control board installed in it. As soon as the commercial
dishwasher sends the release signal to the control board, the EcoPlus PDRX commands
the SMARTPOWER
valve opens and clean water flows into the product cylinder from below, releasing rinse
5
aid from the inserted rinse aid capsule. The rinse aid solution collects in the collection cup
of the dispenser until a float switch in the collection cup switches off the solenoid valve.
6
TM
Rinse Dispenser
1
2
3
4
5
6
TM Rinse Dispenser is an automatic dispenser for Ecolab pressed
to accommodate the pressed rinse aid
2
and a spray nozzle
7
.
10
and removing the product cylinder Fig. 1 , all parts are
3
TM
Rinse Dispenser is connected to an EcoPlus PDRX dispenser and
TM
Rinse Dispenser for the entire cleaning process. The solenoid
23
Set-up / Functional description
1
7
8
5
6
Backflow preventer
7
Clean water supply line
8
Rinse aid supply connection
9
Rinse-Pulse-Timer board
10
Spray nozzle
11
Base
12
), a product cylinder
12
, a solenoid valve, a
5
. To improve the rinse aid concentration
11
1
12
MAN054125 Ver. 01-04.2024
10
11
9