Troubleshooting - Cito Rsp Easy Betriebsanleitung

11. Troubleshooting

QV11.0
Installation of the protective impression cylinder jacket
Problem
Poor adhesion of the protective
No adhesion of the protective impression
cylinder jacket
Too strong adhesion of the protective
impression cylinder jacket
Installation of the base blanket
Problem
Base blanket is not held in blanket clamp-
ing bar
Removal of the base blanket
Problem
Base blanket jams when being removed
from the rubber blanket clamping bar
Commissioning of RSP Easy
Problem
Imprint of the diecutting form on the
impression cylinder
Damage to the plastic material of the
base blanket
Tool above bearer height
Collision of the diecutting form with the
grippers
56
Operating Manual
Possible cause
Surface of the impression cylinder is dirty
Mark 3 cylinder surface (after perfecting)
from Heidelberg or similar surface
PerfectJacket cylinder surface from Heidel-
berg or similar surface
Protective impression cylinder jacket for
press "with perfecting" used on chrome
impression cylinder
Possible cause
Locking pin not engaged
Clamping bar not engaged in fastening
clamp
Possible cause
Locking pin not released
Possible cause
Protective impression cylinder jacket not
installed
Tool above bearer height
Incorrect thickness of calibration sheets/
packing sheets
Film with which the blanket cylinder
has been fitted has not been taken into
account
Tool stuck in the gripper margin of the
base blanket
Solution
Clean the impression cylinder with IPA
before sticking
Use protective impression cylinder jacket
for press "with perfecting"
No protective impression cylinder jack-
et available
Use protective impression cylinder jacket
for press "without perfecting"
Solution
Engage locking pin
(see page 40)
See page 40
Solution
Release locking pin with tommy bar (see
page 47)
Solution
Install protective impression cylinder jack-
et (see page 38)
See below: tool above bearer height
Correct the cylinder packing height (see
page 49)
Correct the cylinder packing height (see
page 49)
Keep the gripper margin free when
mounting the base blanket
(see page 36)