Mounting The Rsp Protective Impression Cylinder Jacket - Cito Rsp Easy Betriebsanleitung

3. Mounting the RSP protective
impression cylinder jacket
QV3.0
38
Operating Manual
1
IMPORTANT NOTE:
Use the RSP Easy only with original accessories!
When using the RSP Easy declamp blanket and offset printing plate in the respective
printing unit!
Switch off the ink ductor, inking form and dampening form rollers.
When using in the coating unit: Remove the coating roller!
With two-roller coating units, set the spacing between the blanket cylinder and appli-
cation roller to the maximum distance!
Never use damaged or worn RSP system components!
When installing and removing the RSP protective impression cylinder jacket, we rec-
ommend wearing safety gloves (RSP accessories).
To remove the RSP protective impression cylinder jacket safely and easily, we recom-
mend our removal aid (RSP accessories).

Mounting the RSP protective impression cylinder jacket

• Set the respective printing unit manually to "print" and the spacing from blanket
cylinder to impression cylinder to 0.00 mm.
• Remove about 5 cm of the protective tape from the front edge of the protective
impression cylinder jacket and affix the protective impression cylinder jacket about
3 mm from the impression grippers and in the middle of the sides to the clean
impression cylinder at the print start (Fig. 1).
2
1
3