Using The Example Of Heidelberg Quickmaster - Cito Rsp Easy Betriebsanleitung

4.2 Installation of the base blanket

(using the example of Heidelberg Quickmaster 46)

QV4.2
42
Operating Manual
1
BEFORE INSTALLATION OF THE RSP EASY:
Switch off the plate damper.
Switch off the ink vibrator and the plate inkers.
Fit a printing plate which is no longer required.
Install the protective impression cylinder jacket (see page 38).
Remove the blanket and packing sheets.
The automatic rubber blanket or impression cylinder wash-up device must not be used.
Installation of the base blanket into the print unit
• Inch the press forwards until the front lock-up shaft is easily accessible.
• Insert the front clamping bar of the base blanket into the fastening clamps of the
front rubber blanket lock-up shaft and push it against the spring force towards
the operating side until the clamping bar is fully engaged with the lock-up shaft.
• Insert calibrated packing sheets of appropriate thickness (for determination of
the packing height see page 48) beneath the base blanket as far as the packing
sheet fastening bar (Fig. 1).
• Hold the rear clamping bar of the base blanket together with the calibrated pack-
ing sheets firmly under tension and feed in by inching forwards, until the rear
lock-up shaft is accessible.
• Insert the clamping bar into the rear lock-up shaft and push it against the spring
force towards the operating side until the clamping bar is properly engaged with
the rubber blanket lock-up shaft.
• Secure the base blanket to the lock-up shaft using a torque wrench set to 20 Nm
(Fig. 2).
1 2 3 2 4