Troubleshooting - Brandt FE1222X Bedienungsanleitung

self-cleaning enamel that removes the grease
while the oven is functioning. The side panels
are reversible, doubling the lifetime of the
coating.
To remove the self-cleaning panels, fi rstly
remove the side rails (3.2.1) (3.2.2).
If the panels are not performing the self-
cleaning process suffi ciently, they will need
regenerating. To do this, remove all the
accessories and utensils from the inside of
the oven. Thoroughly clean the oven surfaces
that are not self-cleaning. Select the
function.
Set the temperature to 250ºC and set the
time between 30 and 60 minutes, depending
on how dirty the oven is.
When the cleaning programme ends and
the oven has cooled down, wipe the self-
cleaning elements with a damp sponge. They
will then be totally functional again.
Note: Do not use specifi c oven cleaning
products to clean the catalytic walls.
Do not scrape the surface with metal
scouring pads or sharp or pointed
instruments.
3.4 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before
removing it.
• Never use steam cleaning machines.
4

Troubleshooting

You can solve the following problems yourself:
4.1 4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
8
4.4 A beep is sounding. The selected
temperature setting has been reached. The
cooking cycle is complete.
4.5 The oven makes a noise after cooking.
This is normal, as the fan keeps running until
the temperature inside and outside the oven
is reduced.
4.6 "0 00" appears on the display. The
temperature sensor has failed. Call the
Technical Service.
4.7 "AS" appears on the display. The oven has
been functioning for several hours and has
switched off automatically for safety reasons.
Do not try to repair the oven yourself. Call
the technical assistance service.
5
Safety
• The oven must be installed by an authorised
installer in accordance with the manufacturer's
instructions and diagrams.
• The electrical installation must be dimensioned
for the maximum power indicated on the
reference plate and the electrical socket must
have a regulatory earth connection.
• The mains circuit supplying the oven must have
a single-pole cut-off switch with at least 3 mm
between contacts.
• If the power cord is damaged, it must be
replaced by the after-sales technical service or
by similarly qualifi ed staff, to avoid hazard.
• Ensure the appliance is unplugged from the
mains before replacing the oven lamp, to avoid
electric shock.
• Do not use abrasive cleaning products or metal
scouring pads to clean the oven door, as they
could scratch the surface and cause the glass
to shatter.
• Keep small children away from the oven. It
has accessible parts that can heat up during
functioning.
• Do not touch the heating elements inside the
oven.
e n g l i s h