A Pp Co Ntro L; Pairing Mode; H E At Set Ting - H E Ating Perio D; Service, Sto R Ag E A N D Ca Re - Lenz Rcb 1400 Handbuch

INSTRUCTIONS FOR USE / ENGLISH
Turning off:
Pressing the control button again turns the battery pack off.
OFF
Note:
The app must be closed to be able to switch off the battery pack.
The battery pack can still be turned on for 24 hours via the
APP, but after that, only by pressing the button.
A P P C O N T R O L
The lithium packs rcB 1400 / lithium packs rcB 2000 can
be controlled via the Lenz heat app* for smartphones. The
battery packs must be in "Pairing Mode" to be able to couple
them properly with the smartphone.

Pairing mode

Please switch the desired battery packs to "Pairing Mode".
To do so, press the control button (Fig. 1.3.) for approx. 10
seconds until the heat setting displays (Fig. 1.2.) are blinking
and then immediately release the control button. The LED in
the middle is illuminated steadily.
LED, steady on – Pairing mode
Note: The Pairing Mode remains active for 2 minutes!
If no pairing takes place during this time, this mode will
end automatically!
**The optional Lenz heat app for convenient control is available
for download via the Android Play Store and the Apple Store.
H E AT S E T T I N G – H E AT I N G P E R I O D
For heating power and heating period data, please see the
table on the product packaging. You can also access the
data online at www.lenzproducts.com
– 164 –
The heating period per charge depends on the selected
heat setting, the ambient temperature, the battery packs,
and the charge state as well as the age of the battery packs
S E R V I C E , S TO R AG E A N D C A R E

Storage mode

The storage mode half charges the battery packs and then
puts them to sleep, so your battery packs can be stored in
perfect condition.
1. The battery packs must be discharged to start the storage
mode. If needed, discharge the battery packs using your
heating product.
2. Start the charging process as usual (see Charging process)
3. To start the storage mode, press and hold the control
button (Fig. 1.3.) for 3 seconds. All three LEDs of the
charge indicator will blink three times.
4. The first two LEDs of the charge indicator (Fig. 1.2) show
the increasing progress of the charging process.
5. Once the battery packs are half charged, the charging
process ends automatically and the charge indicator LEDs
(Fig. 1.2) are switched off.
6. After the storage mode has finished, store the battery packs
as described in "Storage".
Important note:
• If the battery packs are more than half charged, the storage
mode will automatically be prevented, and this will be indicated
by the middle LED on the battery packs blinking. Disconnect
the battery packs from the Charge Box and connect them to
your heating product to discharge them. Afterwards, restart the
charging process and the storage mode.
LED blinking - Error
– 165 –