Lithium Pack Rcb 1400; Lithium Pack Rcb 2000; Charge Box (Abb. 2.2); Tech Nica L Specificatio Ns - Lenz Rcb 1400 Handbuch

INSTRUCTIONS FOR USE / ENGLISH
T EC H N I C A L S P EC I FI C AT I O N S
lithium pack rcB
1400
(LZ-PPX-060)
lithium pack rcB
2000
(LZ-PPX-070)
Charge Box
Input: 5 VDC / 2A
(LZ-CBX-010, incl.
USB cable)
FI R S T U S E A N D C H A R G I N G
Important note:
The battery packs must be charged before using them
for the first time.

Charging procedure

1. Connect the USB cable (Fig. 2.1) to the Charge Box (Fig. 2.2)
and a USB power supply unit (5 V, 2 A, not included in
delivery) and plug the USB power supply unit into a socket.
2. Place both battery packs into the Charge Box (Fig. 2.2).
Please check the illustration on the Charge Box to ensure
proper orientation. The battery packs can be charged in
any operating mode.
3. The charging process starts automatically.
4. The charge indicator (Fig. 1.2) shows the progress of the
charging process as it slowly rises.
5. The charging status can be monitored by looking at the
LEDs on the battery pack, which will light up in ascending
order as the charge increases. It can also be optionally
monitored with the Lenz heat app* convenient control app.
6. Once the battery packs are fully charged, the charging
process ends automatically and the charge indicator LEDs
(Fig. 1.2) are switched off.
– 160 –
Output: 3.7 V /
2800 mAh
Output: 3.7 V /
4000 mAh
Output: 5 VDC /
2A
7. After the end of the charging process, please remove both
battery packs from the Charge Box. (Fig. 2.2)

Fast-charge mode

1. If the control button (Fig. 1.3.) is pressed once briefly
during the charging process, the battery packs switch to
the fast-charge mode.
2. The charge indicator (Fig. 1.2) shows the increasing
progress of the fast-charge mode.
3. Once the battery packs are fully charged, the charging
process ends automatically and the charge indicator LEDs
(Fig. 1.2) are switched off.
4. The charging status can be monitored by looking at the
LEDs on the battery pack, which will light up in ascending
order as the charge increases. It can also be optionally
monitored with the Lenz heat app* convenient control app.
5. After the end of the charging process, please remove both
battery packs from the Charge Box. (Fig. 2.2)
Important note:
￭ If an attempt is made to charge the battery packs
outside of the specified ambient temperature range
(see safety precautions), the charging process will be
prevented automatically and this will be indicated by
the lower LED on the battery packs blinking. Disconnect
the battery packs from the Charge Box and restart the
charging process at room temperature.
LED blinkiing – Temperature error
Because naturally occurring minimal differences due to
￭
production can occur, the charge indicator in the Lenz
heat app* only serves as a general indicator.
￭ Charge the product after every use. This helps extend
the life of the battery packs and ensures that the product
is ready for use at any time.
• The battery consists of lithium ion cells and can be
charged in any state. For this reason, the battery does
not need to be fully discharged before charging.
– 161 –