Napoleon Wireless Thermometer withTimer Benutzerhandbuch Seite 7

Operations
1. Keep the base transmitter as close as possible to the receiver sensor to
ensure consistent synchronization between base transmitter and receiver.
After setup is complete, keep the units within 200 feet of each other.
2. Turn on the base transmitter by pressing
and holding the On/Off button for 3 seconds.
" " LED will light and blink intermittently
when the base transmitter powers up.
3. Turn on the receiver unit by moving the
left toggle to the middle position
(Temperature mode), "
left position (Timer mode) "
4. The receiver will automatically search
for the signal from the base transmitter.
The receiver's signal light "
intermittently indicating the receiver is
searching for a signal from the base transmitter.
The Black triangle of the signal light will remain
it when the connection has been established.
5. The Base/Transmitter will power down if the
probe reads below 120 °F (50 °C) for more than
2 hours. To restart, press and hold the On/Off
button for 3 seconds.
" or to the
"
" will blink
7
2
On/Off Button
Base Transmitter
H H M M
S S
H H M M
S S
Signal Light:
Black Triangle stays lit
when connected
3
4