2.8 Blocked Cutting Cylinders; Adjustments Lubrication And Maintenance; Slopes; Introductory Note - Textron Ransomes Highway 2130 Montageanleitung

2 SAFETY INSTRUCTIONS

2.8 BLOCKED CUTTING CYLINDERS

• Stop the engine and make sure all moving
parts are stationary.
• Apply brakes and disengage all drives.
• Release blockages with care. Keep all parts of
the body away from the cutting edge. Beware
of energy in the drive which can cause rotation
when the blockage is released.
• Keep other people away from the cutting units
as rotation of one cylinder can cause the
others to rotate.
2.9 ADJUSTMENTS, LUBRICATION AND
MAINTENANCE
• Stop the engine and make sure all moving
parts are stationary.
• Apply brakes and disengage all drives.
• Read all the appropriate servicing instructions.
• Use only the replacement parts supplied by
the original manufacturer.
• When adjusting the cutting cylinders take care
not to get hands and feet trapped when rotating
cylinders.
• Make sure that other people are not touching
any cutting units, as rotation of one cylinder
can cause the others to rotate.
• To reduce the fire hazard, keep the engine,
silencer and battery compartments free of
grass, leaves or excessive grease.
• Replace worn or damaged parts for safety.
• When working underneath lifted parts or
machines, make sure adequate support Is
provided.
• Do not dismantle the machine without
releasing or restraining forces which can cause
parts to move suddenly.
DANGER - Indicates an imminently hazardous
situation which, if not avoided, WILL result in death
or serious injury.
WARNING - Indicates a potentially hazardous
situation which, if not avoided, COULD result in death
or serious injury.
CAUTION - Indicates a potentially hazardous
situation which, if not avoided, MAY result in minor or
moderate injury and property damage. It may also be
used to alert against unsafe practices.
WARNING
Hydraulic Fluid escaping under pressure can
penetrate skin and do serious damage.
Immediate medical assistance must be
sought.
PARTS AND FITTING INSTRUCTIONS FOR HIGHWAY 2130,
AND PARKWAY 2250 PLUS, ROPS FRAME
3.0
DO NOT USE ON SLOPES GREATER THAN 15°
The slope 15° was calculated using static stability
measurements according to the requirements of
EN 836.
3.1
IMPORTANT!
Read all instructions thoroughly before beginning
installation. When you complete the installation, put
this instruction with operator's manual in the bag on
the vehicle. These instructions alert you to certain
things you should do very carefully, if you don't, you
could: hurt yourself or bystanders, hurt the next
person who operates the equipment, or damage the
accessory or the vehicle it is used on.
It is important that all of the steps listed in
this manual are completed. Failure to do so
will result in non-compliance with EN-836
and OECD Rops test certificate, and could
result in serious injury or death.
Roll over protection is only provided with
the frame in the raised position,
the seat plate bolted down and the seat belt
securely fastened around the operator.
When assembling the frame it is important
that only the specified hardware is used.
Should items of hardware be missing from
the kit, use only replacements that conform
to those specified on page 11.
Always keep the ROPS frame mounted. Never alter,
remove, bend, repair or attach any equipment to the
ROPS frame. DO NOT operate tractor with a damaged
or modified ROPS frame.

SLOPES

INTRODUCTORY NOTE

WARNING
WARNING
WARNING
GB-3