Renkforce 1408618 Bedienungsanleitung Seite 50

• Tap to select the LEDs that you want to add to the group.
The small check marks of the selected LEDs turn blue
by this.
• To save, tap "Save".
• Switch on the voltage supply of the LED drivers and tap
"Save" within 5 seconds once the blue LED at the LED
driver is lit (after approx. 1 second).
The LED panels usually should flicker briefly here.
How the binding mode is activated depends on
the lamp. For the LED driver, it is active for 5 sec-
onds once the driver is supplied with voltage, for
example.
For this, observe the respective instructions of the
lamp.
50