System Component Combinations - Elektra Beckum Sdv 250 Rc Bedienungsanleitung

User Responsibility
Any other use requires the written consent of Metabo GmbH, Business Unit Elektra Beckum, P.O.Box 1352, D-
49703 Meppen, Germany. Retain proof of purchase! You are only entitled to claim warranty against proof of
purchase. Please see back cover for manufacturer representative's address nearest you.This machine will perform
in conformity with the description contained in the instructions provided. This machine must be checked
periodically. Defective equipment (including service leads) should not be used. Parts that are broken, missing,
plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or replacement
become necessary, it is recommended that such repairs are carried out by qualified persons approved by the
equipment manufacturer or its representative. This machine or any of its parts should not be altered or changed
from standard specifications. The user of this machine shall have the sole responsibility for any malfunction which
results from improper repair by anyone other than qualified persons approved by the equipment manufacturer or
its representatives.
Contents
1 Scope Of Application
1.1 System Component Combinations
1.2 Specifications
2 Description
2.1 SDV 250 RC Controls
2.2 SDV 250 E Controls
3 General Instructions For Start-Up
1 Scope Of Application
A Separate Wire Feed Unit offers a greater range of action and more flexibility in welding operations over a
welding power source with intregated wire feed only, as the maximum length of the torch leads is rather limited
for many welding operations.
The ELEKTRA BECKUM Separate Wire Feed Units are suitable for welding ferrous metals and aluminium as
specified for the welding power source.

1.1 System Component Combinations

MIG/MAG 350 E
MIG/MAG 300 SEC
MIG/MAG 350 SEC
MIG/MAG 400 SEC/W
MIG/MAG 500 SEC/W
MIG/MAG 300 SEC/X
MIG/MAG 350 SEC/X
MIG/MAG 400 SEC/WX
MIG/MAG 500 SEC/WX
SEK - W
SEK - WX
SEM - W
SEM - WX
W - water cooled torch
x - machine without intregated wire feed
1
- requires adaptor to operate (stock-no. 090 201 1285)
1.2 Technical Specifications
Voltage motor
Voltage electronic controls
Range setting
Protection class
Dimensions
Weight
SDV 250 E SDV 250 RC
1
1
1
1
1
1
1
1
SDV 250 E (-T)
28 V
-
stepless
extra-low voltage
605x270x410
26.5 kg
3.1 Transportation
3.2 Installing The Wire Spool
4 Trouble Shooting
5 Trouble Shooting
5 Spare Parts List
6 Wiring Diagram
SDV 250 E-T
-
1
1
1
1
SDV 250 RC (-T)
stepless
extra-low voltage
605x270x410
27.0 kg
ENG
SDV 250 RC-T
28 V
9 V