Remote Control - Yamaha SRT-1000 Bedienungsanleitung

No surround Stereo playback is selected.
effect.
The volume is too low.
The volume of the surround left
and right channels is low.
The TV or playback device is set
to output 2-channel audio (such
as PCM) only.
The correct SRT position mode is
not selected.
Sound beams are not reflected
effectively off walls because of the
shape of the room, etc.
Noise is heard. The unit is too close to another
digital or high-frequency device.

Remote control

Problem Cause
The unit cannot The unit is out of the operating
range.
be controlled
using the remote
The batteries are weak.
control.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
The unit does
The TV remote control key was
not learn TV not held down long enough.
remote control
The TV remote control does not
operations.
use infrared signals. (Some
remote controls may not work
even if it uses infrared signals.)
The position where you operated
the TV remote control is not
appropriate.
The batteries of the TV remote
control are weak.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
The transmission of the remote
control signal was disturbed by
the TV screen light.
Select the surround mode key to
change for surround playback (p.10).
Turn up the volume (p.8).
Turn up the volume of the surround left
and right channels (p.11).
Change the digital audio output setting
on the TV or playback device.
Select a SRT POSITION key on the
remote control which is best suited for
your listening environment.
Use of the sound reflection board (sold
separately) is recommended (p.21).
Move those devices away from the
unit.
Remedy
Use the remote control within the
operating range (p.2).
Replace with new batteries (p.2).
Adjust the lighting angle, or reposition
the unit.
Hold down the key for more than 1
second twice or three times (p.14).
The TV remote control learning
function cannot be used in this case.
Use the supplied remote control to
operate the unit.
Operate the TV remote control at the
appropriate position (p.14).
Replace with new batteries.
Adjust the lighting angle, or reposition
the unit.
Turn off the TV and perform the
learning operation again (p.14).
Sound is coming Audio output is enabled on the
TV.
from the TV
when the unit
volume is turned
up with the TV
remote control.
(when TV remote
control learning
function is used)
The power of the The power of the TV was on when
unit and of the you performed the learning
operation.
TV switch in the
opposite
direction. (For
example, the TV
is turned off if
the unit is turned
on.)
(when TV remote
control learning
function is used)
Change the TV setting to disable the
TV speaker output. If a setting to
disable the speaker output is not
available on your TV, try the following
methods.
- Connect headphones to the
headphone jack on the TV.
- Set the TV volume to minimum.
Press the power key on the TV and
(power) on the front panel of the
unit to turn them on and then press the
power key on the TV remote control to
turn them off.
19