Alert Settings - Tfa View Meteo Bedienungsanleitung

6.5 Alert settings

y Press and hold the ALERTS button (Fig.2-A) for three seconds to enter the alert setting mode.
OFF flashes and the first setting option HI ALERT (upper limit) of the outdoor temperature is displayed. If you do not want to set this alert,
y
press the ALERTS button again to move to LO ALERT (lower limit) of the outdoor temperature.
To activate (ON) or deactivate (OFF) the alert setting function, press the "+" or "-" button (Fig.2-D+E).
y
Press the ALERTS button to confirm the settings. The corresponding value flashes. Press "+" or "-" button to adjust
y
the respective alert value.
Confirm with the ALERTS button and go to the next setting.
y
The sequence of the available alert settings in this mode is shown as follows:
y
HI and LO ALERT Outdoor temperature
y
HI and LO ALERT Outdoor humidity
y
HI and LO ALERT Indoor temperature
y
y HI and LO ALERT Indoor humidity
Alarm event:
In the event of an alarm, the corresponding symbol
y
Stop the alarm sound with any button.
y
The alert symbol continues to flash until the measured value is within the alarm limits.
y
6.6 Wi-Fi Connection
Press the SET button (Fig.2-F) once briefly in normal mode to display the Wi-Fi status for 3 seconds.
y
SEE APP TO CONNECT - the station is trying to connect with the already registered Wi-Fi network or is in Wi-Fi configuration mode.
y
LOST WIFI - the station has not yet been connected to the local Wi-Fi network or currently has no contact with the Wi-Fi network already
y
registered.
ALL OK CONNECTED - the station is actively connected to the Wi-Fi network.
y
The Wi-Fi symbol next to the time is permanently displayed when the station is actively connected to the Wi-Fi network.
y
The Wi-Fi symbol next to the time flashes when the station is in the process of connecting to the already registered network or in
y
Wi-Fi configuration mode.
If no information for the local Wi-Fi network has been transferred yet or if it has to be transferred again (because the network name or
y
password has changed, for example), initiate a new configuration via the app.
If the station has not yet been connected to the local Wi-Fi network or to the app/account, please add the station via the device
y
management (described in detail in point 5.2).
If the station has already been registered in the app or the account and only the Wi-Fi configuration needs to be performed again,
y
will be flashing and an alarm tone will sound 5 times per minute.
24