Klarstein ON-THE-ROCKS Bedienungsanleitung Seite 20

EN
20
Operation
1. Plug out, and clean the water reservoir by adding water, then take plastic plug
away to drain out the water from water reservoir.
2. Reinstall the plastic plug, and add appropriate clean water. After connecting the
power supply well, press and hold „SELECT" button for 3 seconds to activate
pipeline self-clean process. After cleaning, drain out the water by taking plastic
plug away.
3. Open the lid and take out the ice basket to add appropriate water into water
reservoir. Note: The water poured into water reservoir should be lower than the
water reservoir's MAX position. When water volume goes beyond the max, please
open the bottom water drain plug to drain the spare water out. Then close the
transparent lid.
4. Select the desired ice size, the default size of machine is large one. Note: Please
select the (S) when ambient temperature is below 15°c.When the ambient
temperature is higher than 30°C, Large ice cube sizes are recommended.
Note: For the first three cycles, the ice may be small and irregular in size. Note:
When the ice collecting tray is full please remove the ice immediately, Do not allow
the ice collecting tray to overfill.