Cleaning And Maintenance - Ayce Rlp16 Gebrauchsanweisung

Replacement of the blade:
1. Place the machine on a flat surface.
2. Use the Allen key (12) to remove the locking screw (2) and washer (Fig.8-1).
3. Use the socket spanner (11) to remove the nut (4) (Fig.8-2).
4. Turn over the machine.
5. Use screwdriver (10) to remove the 2 screws then take off the blade cover (a)
(Fig.8-3).
6. Remove the bolt (b), and then the retaining block (c) and 2 blades can be
removed for replacement.
7. After replacing or sharpening the blade, follow the instructions above to
reinstall the blade in reverse order.
The blades can be replaced individually without worrying about the position of
the blades. After restarting, the opening will automatically return to the normal
size.
Be careful not to allow any foreign matter to become attached to the blade
gear and do not damage it.

Cleaning and maintenance

WARNING! Before performing any work, make sure the tool has
stopped running and remove battery pack from machine.
Warning! Always wear protective gloves when using, adjusting or
cleaning the machine.
Cleaning
- Keep all safety devices, air vents and the motor housing free of dirt and dust
as far as possible.wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
- We recommend that you clean the device immediately each time you have
finished using it.
- Clean the equipment regularly with a moist cloth and some soft soap. Do not