Ayce RLP16 Gebrauchsanweisung Seite 104

Self-discharge of batteries! Remove the battery from the charger once
it is fully charged.
OPERATION
Product Operation
Setting up
1. Insert the battery pack into machine.
2. Switch ON the power switch of the machine. The LED display indicator will be
green and the buzzer will beep twice.
3. Double click the trigger, the buzzer will beep once and the scissor blades will
automatically open.
4. Normal operation: press trigger to close the blades and release the trigger to
open blades.
5. Blade closing: continue to press the trigger, the buzzer will beep once means
the blade will stay closed.
6. Protection function: If the trigger is not activated, the scissors will enter
standby mode after 1 minute. Double clicking on the trigger will reactivate the
machine. The power switch will automatically turn off after 10 minutes of
inactivity.
7. Before operation, in order to see if the scissor performances well, please
press the trigger to close and release the trigger the blades without cutting
anything.
Finger protection
This machine has a protection circuit to ensure that if the operator's finger
reaches between the blades during operation, the machine will automatically
stop to prevent injury.
NOTE: The glove is an insulator, so if the gloved finger reaches between the
blades, the machine will not provide protection.
If the fingers other than the operator (the fingers of others) extend between the
blades, the machine will not provide protection also.
If the operator holds the wet branch in one hand and presses the switch with the
GB
101 | 102