Ayce RLP16 Gebrauchsanweisung Seite 105

other, the machine protection system is likely to start and the blade will not
move.
Setting the open wide of blade
In order to improve the operating efficiency, the blade width of the machine is set
to 3 levels. Each time the power switch is pressed, the LED will light up and blade
will change position in turn.
Fig. 6
Packing up
1. Press the trigger and hold for a few seconds and then release, the blade will
closed and will not open.
2. Switch off the battery, disconnect the battery pack.
3. Tidy up, clean up and pack the scissor into the tool box
To close the blade 1
Pressing the trigger (Fig. 1 /Item 5) to close the blade.
To open the blade 1
Release the trigger (Fig. 1 /Item 5) to open the blade.
Never operate the machine in an awkward posture. This may cause serious
injury.
The normal grasp posture is as follows: