Mitsubishi Electric PFD-P250-500VM-E Installationshandbuch Seite 7

10
[Fig. 10.0.1]
<A> Model 250
A Filters (2)
B Filter cover
C Side panel: 14 screws
D Front panel: 6 screws
E Front panel:
2 chains
Detailed view of section A
M Screw
[Fig. 10.0.2]
<A> Model 250
A Linear expansion valve wiring
B Clamp
C Remote controller wiring
<B> Model 500
A Linear expansion valve wiring
B Clamp
C Remote controller wiring
F Rear panel: 9 screws
C Side panel: 14 screws
G Rear panel: 8 screws
A
(on four corners)
K Bolt 1
M Screw
L Bolt 2
Pull these pins up and down respectively
to remove the front panel.
E Thermistor wiring
10.0
<B> Model 500
H Filters (3)
C Side panel:
14 screws
J Front panel:
2 hinges on each
<Dimensions and weight of parts>
Height (mm)
Heat exchanger 1120+510
unit (top)
Fan unit
(bottom)
Decoration
panel
* Length of protruded pipe (removable)
D Lamp wiring
B Clamp
Float switch wiring
B Clamp
D Lamp wiring
E Thermistor wiring
Float switch wiring
I Rear panel: 7 screws on each
B Filter cover
C Side panel: 14 screws
A
(on four corners)
Width (mm) Depth (mm)
P250:1380
780
*1 P500:1980
P250:1380
860 780
P500:1980
— —
—
G Rear panel: 8 screws
Weight (kg)
P250:158
P500:246
P250:128.5
P500:159
P250:93.5
P500:115
7