Technical Specifications - VINCENT SV-400 Bedienungsanleitung

Symptom
Poor sound quality
The remote control
cannot perform any
functions
Humming low
frequency noise is
audible, even as
no audio source is
playing back
Frequency response:
Nominal Output Power at 8Ω:
Input sensitivity:
Total Harmonic Distortion:
Signal to Noise Ratio:
Input Impedance:
AC power connection type:
Inputs:
Outputs:
Dimensions:
Weight:
Colour:
Vincent Vincent
38 38
Possible Cause
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
A record player has been connected to a line
level input without using a phono preamplifier.
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the chapter "Tips".

TECHNICAL SPECIFICATIONS

20 Hz - 20 kHz ±0.5 dB
2x 50 W
200 mV
< 0.1 % (1 kHz, 1 W)
> 90 dB
47 kΩ
230 V/50 Hz
5x RCA stereo, 1x USB
2 stereo loudspeaker sockets, 1x PRE stereo RCA,
1x REC stereo RCA
430 x 98 x 335 mm
9,5 kg
silver / black
Countermeasure
Check the cables and cable connections.
Interconnect a phono preamplifier.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.