Rocks 20V AQ-ONE SYSTEM Anweisung Seite 8

• Engine
• Tension
• Dial size
• Speed
• Spindle size for blade clamping
• Scales
• Optional equipment (only in OK-03.4323)
• Battery
• Charger
• Charging time
SERVICE
Battery
Always fully charge the battery before using it for the first time. The battery will heat up while charging, this is a normal situation.
The battery is a consumable part that is calculated for 500 charge cycles, after which its efficiency may decrease. In this case,
the battery should be replaced by buying a new one. The battery has a limited warranty of up to 1 year.
The battery has overload safety systems that protect the device and will activate if the device overloads and overheats. Wait about
30 minutes for the device and battery to cool down. However, in some cases, permanent damage to the battery can occur. In such
cases, the battery must be replaced with a new one. In the event of overload damage, the battery is not subject to a complaint.
Charge the battery regularly, at least once every 3 months, even if the device is not in use. Stop operation of the appliance if
the battery is discharged and the appliance stops during operation. Do not turn it on again, just replace or recharge the battery
immediately. Attempting to operate with a discharged battery may lead to permanent damage to the battery.
Removing the battery:
1. press the lock buton,
2. eject the battery pack.
Device
When preparing the tool for operation, while installing and changing attachments, the battery must be disconnected from the
machine. Keep the tool clean, especially in technically important areas: switches, battery connection, attachment holder, housing
around the engine, air vents. Contamination of these areas can lead to permanent damage to the tool. Clean the tool with
a clean, damp cloth and blow with air.
• Brushless
• DC 20 V
• 125 mm
• 3 000 – 10 500 rpm
• M14
• 2,5 kg
• 400 A
• 21 V / 5 Ah
• 2 h