Safety Rules - Rocks 20V Aq-One System Anweisung

SAFETY RULES

READ AND UNDERSTAND ALL INSTRUCTIONS FOR THE USE AND MAINTENANCE OF THE TOOLS. FAILURE TO
FOLLOW INSTRUCTIONS MAY RESULT IN PERSONAL OR PROPERTY INJURY AND VOID THE WARRANTY
Power tools are intended to be used by qualified adults. During operation, tools produce sparks that can ignite dust or fumes. Do
not use power tools in unfavorable, flammable, explosive and humid environments.
Always use the original power tool battery, do not modify electrical plugs and connections.
Avoid contact with grounded objects and other live tools.
Do not expose power tools to rain or moisture.
Only use a working charger cable. The cable must not be cut.
Do not use tools when you are tired or under the influence of stimulants. Use personal protective equipment, in particular: safety
goggles, hearing protection and protective gloves. When working in dusty environments, use additional masks to protect the
respiratory tract.
Avoid accidental starting. Make sure the switch is in the off position before connecting to the battery. When replacing accessories
in the tool, turn off the unit and disconnect the battery.
Take your time. Maintain proper posture and balance at all times. This allows you to better control the tool in unexpected situations.
Use protective clothing. Do not wear loose clothing or jewelry.
Principles of working with AQ-ONE tools
• Only use accessories that are adapted to the size of the handle.
• Never use damaged accessories.
• Check the operation of the tool during idle operation for 30 seconds. If vibrations or faults occur during this time, switch off
immediately.
• Keep the air vents around the engine clean.
• The tool is used to work in a dry environment. Never work on wet ground or in the rain.
• Make sure the power supply is in accordance with the requirements of the tool. Never use the tool with the wrong power supply.
• Always use knowledge and common sense when working with tools, especially in non-standard working conditions. First of all,
take care of your own safety at work and the safety of bystanders.
CAUTION!
Despite the use of inherently safe design, the use of safety measures and additional protective measures, there is always
a residual risk of injury during work.
DESIGN & SPECIFICATIONS
1. Spindle lock
2. Main switch
3. Spindle
4. Blade guard
5. Handle
6. Speed controller