Cleaning And Maintenance - Pur Line Rafy 170 Anleitung

CLEANING AND MAINTENANCE

· Unplug the appliance before cleaning.
· Empty water tank to avoid odor occurring when not in use.
· After few days operation, dust and dirt may reserve in water tank. It is recommended to change
water and clean water tank frequently.
· After long time operation, the filtration mesh becomes clogged with dust and dirt, which will
greatly affect the unit's performance. It is recommended to clean the filtration mesh frequently.
· Use a soft cloth to clean the appliance. Do not use solvents or harsh chemicals. Never use direct
water. Do not allow water to come in contact with the control panel.
· Do not clean with metal sourcing pads. It may scratch the surface or cause electrical shock.
To clean the filter and the tank, first remove filtration mesh
(1) from the back, then the fixing plate (2) and finally the
honeycomb panel and filter frame (3,4).
FILTER
1. Clean filter and panel with mild detergent and soft brush.
3. Make sure filter and panel are completely dry before
installing.
WATER TANK
1. Clean the water tank with a little mild detergent on a towel
and then rinse in water.
2. Dry the tank with a soft cloth.
OUTER CASING
The surface of the appliance can be cleaned using wet cloth with a little mild detergent. Do not rinse directly
with water.
STORAGE
Switch off and unplug the unit.
Clean or change the filter.
Clean and dry the water tank. Turn on the unit for a while, so the inside can dry out completely.
It is recommended to store the unit in it's original carton. Do not stack heavy objects on top of the unit.
TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit's problem. You may check against the
following list before send for repair:
Problem
Not working
Dedust effect/
ventilation not
good.
Notice:
· If the problem cannot be found in the list or it persists, please contact our service center or a qualified
technician for further inspection.
· Do NOT open and repair the unit by yourself. Use only qualified agents for repairs or services.
Possible reasons
1. The plug is not securely inserted into
the socket or not connected well.
2. The "ON/OFF" button is not pressed.
1. The filtration mesh is clogged with
dust and dirt, which affects the unit's
performance.
2. The air vent is obstructed.
EN
4
Solutions
1. Insert the plug pin into the wall
socket and make sure it is connected
well.
2. Press "ON/OFF" button after plugged.
1. Clean the filtration mesh.
2. Remove the foreign objects from the
air vent.
11
3 1
2