Control Panel; Remote Control - Pur Line Rafy 170 Anleitung

CONTROL PANEL

- ON/OFF: Press once this button to turn on the device. It will start up with "MID" in 3 seconds and then revert
to work under the memorized status. If for first time use, it will start up with "MID" in 3 seconds and then work
with "LOW". Press again this button to turn OFF.
6 fan speeds:
- NORMAL (3 speeds): Press SPEED button to select desired fan speed, MID-HIGH-LOW, in circle turns. The
corresponding air flow speed indicator light will be displayed.
- SLEEP (3 speeds): Press SPEED button to select desired fan speed, MID-HIGH-LOW, in circle turns. The
corresponding air flow speed indicator light will be displayed.
- TIMER: It can be set between 1 to 24 hours, increase by 1 h. intervals. Digital display shows the remaining time.
- LEFT and RIGHT SWING: Press once this button to make horizontal swing of vertical louvers, the SWING
indicator will be displayed. Press again to cancel this function.
- UP and DOWN SWING: The cross blade moves automatically to 90º when the appliance starts. Press this
button to show diffent angles: 90º - 60º to 120º - Any stop - 60º to 120º - Any stop - Auto OFF.
- SPEED: after start Normal or Sleep function, press "Speed" button to choose Low-Mid-High speed.
- COOL: During operation, press this button to start the evaporative cooling function, to humidify the air,
improve the air damp, avoid skin dry and spall. The corresponding indicator lights Cool and Humidifier will be
displayed. Before press COOL button, make sure water in the tank is always no less than min. level required.
The light of humidifier twinkles, if no water during operation, and it will buzz. Press again this button to cancel.
- IONIZER: This function starts automatically when the evaporator is turned on.
- Numeric LED display:
Shows setting time (from 1,2,3... until 24 h.)
Fault detection: If the sensor has problems, the digital panel displays E1.
EN

REMOTE CONTROL

Remote control has the same functions as the unit control
panel
· Do not mix old and new batteries at the same time in remote
controller.
· Take out the batteries when the remote is not in use for a long
time.
10