Cleaning And Maintenance - Pur Line Rafy 100 Anleitung

CLEANING AND MAINTENANCE

· Unplug the appliance before cleaning.
· Empty water tank to avoid odor occurring when not in use.
· After few days operation, dust and dirt may reserve in water tank. It is recommended to change
water and clean water tank frequently.
· After long time operation, the filtration mesh becomes clogged with dust and dirt, which will
greatly affect the unit's performance. It is recommended to clean the filtration mesh frequently.
· Use a soft cloth to clean the appliance. Do not use solvents or harsh chemicals. Never use direct
water. Do not allow water to come in contact with the control panel.
· Do not clean with metal sourcing pads. It may scratch the surface or cause electrical shock.
FILTER
1. Take the filtration mesh handle and pull upwards (fig.2).
2. Clean filtration mesh with mild detergent and soft brush.
3. Make sure filtration mesh is completely dry before installing.
WATER TANK
1. Pull out the water tank.
2. Clean the water tank with a little mild detergent on a towel and then rinse in water.
3. Put the water tank in place after drying the tank with a soft cloth.
OUTER CASING: The surface of the appliance can be cleaned using wet cloth with a little mild detergent. Do
not rinse directly with water.
STORAGE
Switch off and unplug the unit.
Clean or change the filter.
Clean and dry the water tank. Turn on the unit for a while, so the inside can dry out completely.
It is recommended to store the unit in it's original carton. Do not stack heavy objects on top of the unit.
TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit's problem. You may check against the
following list before send for repair:
Problem
Not working
Dedust effect/ventilation
not good.
Notice:
· If the problem cannot be found in the list or it persists, please contact our service center or a qualified
technician for further inspection.
· Do NOT open and repair the unit by yourself. Use only qualified agents for repairs or services.
EN
Possible reasons
1. The plug is not
securely inserted
into the socket or not
connected well.
2. The "ON/OFF" button
is not pressed.
1. The filtration mesh is
clogged with dust and
dirt, which affects the
unit's performance.
2. The air vent is
obstructed.
11
Solutions
1. Insert the plug pin
into the wall socket
and make sure it is
connected well.
2. Press "ON/OFF" button
after plugged.
1. Clean the filtration
mesh.
2. Remove the foreign
objects from the air vent.
fig. 2