Pur Line RAFY 170 Anleitung Seite 11

PARTS
control panel
louvres
air flow outlet
water inlet
OPERATION
1. Pull the unit outwards from the carton and place it on the floor.
2. Check if the spare parts are complete the same as the spare part list:
Part
Remote control
Instruction manual
Wheel
Wheel with stopper
3. Take out the wheels to assemble. Note: Two wheels with stopper are for the two
front holes (fig.1).
4. Filling the water tank: Pull out the water tank compartment at the front of the unit,
about 10 cm up to the locking pin, and fill the tank with water slowly, and slowly pour
water inside (fig 2).
Notes:
- Water level must be between the MIN and MAX line.
- After few days operation, dust and dirt may reserve in water tank. It is recommended
to change water and clean water tank frequently.
- Water shortage warning. When water lower than Min. Level, "Beep" will sound, and
indicator light will flash.
5. To empty the tank, remove the drain cap (fig 3) from the rear part of the appliance.
6. Get the plug to power and turn on the unit power switch. A short "Beep" sound can
be heard and the power indicator will be on.
honeycomb
pad frame
water tank
casters
with brake
Quantity
1
1
2
2
EN
honeycomb
cooling pad
fixing plate
9
filtration mesh
water pump
cap
casters
without brake
fig.1
rueda rueda
con freno