Polti ROLLYSTEAM WD30C Fehlerbehebung Seite 7

EN
PROBLEM / ERROR
How to clean the roller brush
TROUBLESHOOTING
POSSIBLE CAUSE
After each cleaning session
Periodically or after a
thorough cleaning:
SOLUTION
The brush can be automati-
cally cleaned on the station:
to do this, press the button
to start the self-cleaning
cycle.
If you wish to clean the
brush more thoroughly by
hand: gently remove the
roller brush. Rinse it with
clean water to remove any
residue, then let it dry com-
pletely, either by placing it
back on the heated base* or
in open air, before reinstal-
ling it.
*for compatible models
The brush can be automati-
cally cleaned on the station:
to do this, press the button
to start the self-cleaning
cycle.
Remove the roller brush
while keeping it attached to
its locking system. Do not
try to detach it completely,
as this could damage it.
Rinse it with clean water,
then place it in a suitable
protective bag. You can
wash it in the washing ma-
chine using a gentle cycle.
Let it dry completely, either
by placing it back on the
heated base* or in open air,
before reinstalling it.
*for compatible models