Polti ROLLYSTEAM WD30C Fehlerbehebung Seite 6

EN
PROBLEM / ERROR
The roller brush remains dry.
The screw cannot
be tightened.
The cleaning cycle does
not start.
The brush LEDS do not
work.
The display does not
switch on.
Clean water tank indicator
light on.
Dirty water tank indicator
light on.
Visible residue on the roller
or inside the tubes after the
cleaning cycle.
The product leaves some
water traces on the floor
after cleaning.
TROUBLESHOOTING
POSSIBLE CAUSE
Water tank empty.
Water pump malfunction.
Nozzles clogged.
Handle not properly
inserted.
Battery level is equal to or
below 10%.
Water tank empty.
Electrical fault.
Battery discharged.
Electrical fault.
Clean water tank empty.
Dirty water tank full.
The product may have been
used in particularly dirty
conditions or to remove
stubborn debris, making
a second cleaning cycle
necessary.
If the roller is particularly
wet, it may leave water
traces on the floor during
the steam/vacuum clea-
ning phase. This can occur
especially after use on large
surfaces or when cleaning
heavy dirt.
SOLUTION
Fill the tank.
Contact service centre.
Ensure that the handle is
correctly fitted into place.
Recharge the product.
Fill the tank.
Contact service centre.
Recharge the product.
Contact service centre.
Fill the clean water tank.
Empty the dirty water tank.
Repeat the cleaning cycle
to ensure all parts are
thoroughly cleaned.
In these cases, we recom-
mend performing an addi-
tional vacuum-only pass to
remove any residual moistu-
re.