Decommissioning; Maintenance And Cleaning - Renkforce 1034067 Bedienungsanleitung

8. Decommissioning

If the pressure switch is to be disconnected from the garden hose and the garden pump (e.g. for cleaning,
maintenance or storage in winter), proceed as follows:
• Disconnect the pressure switch from the power supply, pull the mains plug from the mains socket.
• Then pull the mains plug of the garden pump from the socket in the rear of the pressure switch.
• Open the water spray or the water tap at the end of the garden hose connected to the pressure switch
to let the water pressure still present escape.
• Slowly remove the garden hose from the pressure switch and then the pressure switch from the garden
pump.
• Empty the pressure switch (and your garden pump). Dry the pressure switch and the mains cable. Keep
the pressure switch (and your garden pump) in a frost-proof and dry room over winter.
Also consider emptying the hoses placed outdoors to prevent frost damage; open any water taps
that may be installed.
• After operation or emptying, a small amount of water may remain in the pressure switch. Therefore, use
a suitable support when storing or transporting it in a vehicle.

9. Maintenance and Cleaning

The pressure switch has no parts that require maintenance by you. Therefore, never open or disassemble
it. Maintenance or repair and opening of the pressure switch in this context must only be performed by a
specialist or specialist workshop.
Before cleaning, disconnect the pressure switch from the mains voltage; pull the mains plug from the
mains socket.
To clean the outside of the pressure switch, a dry, soft and clean cloth is sufficient.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since
these may damage the casing or even impair function.
23