C) Operation - Renkforce 1034067 Bedienungsanleitung

• Ensure that electrical plug connections are in flooding-safe areas; otherwise, there is a danger
to life from electric shock! If required, use suitable protective housings for the plug connec-
tions.
• Protect the mains plug from wetness! Never touch the mains plug with wet hands! There is
danger to life from electric shock!
• The mains cable or mains plug must not be cut off.

c) Operation

• The product must not be operated by children or teens. This also applies regarding persons
who are not familiar with these operating instructions. Persons with limited physical or mental
capacities must only use the product if supervised and instructed by a person responsible for
them.
• Only fresh water with a temperature of no more than +55 °C must be conveyed.
• The conveyed liquid must be clean. If required, use a suitable filter in the suction hose of the
garden pump (e.g. a gross filter with return flow stop at the suction hose end and a fine filter
right at the suction connection of the garden pump).
• The product is not suitable for conveying potable water.
• The product is not suitable for conveying corrosive/caustic, flammable or explosive liquids
(e.g. gasoline, fuel oil, nitro diluent), grease, oils, salt water or sewage from toilets.
• The mains socket to which the pressure switch is connected must be easily accessible. The
mains cable must point downwards from the mains socket so that the water running back at
the cable cannot enter the mains socket.
• The product must not be operated unsupervised.
• The product must not be operated in or close to explosive liquids or gases; there is a danger of
explosion!
• Consequential damage caused by malfunction or interference at the pressure switch must be
prevented by suitable measures (e.g. water level indicator, sensors, alarm devices, etc.).
• The product is only suitable for use in temperate, not tropical, climates.
• Check the entire product for damage before any commissioning, e.g. damage to the casing and
mains cable/plug.
If you find any damage, the product must not be used.
If the product is already connected to the mains voltage, first switch off all contacts of the
associated mains socket by deactivating the circuit breaker or turning out fuse; then switch off
the associated FI protection switch.
Only unplug the pressure switch mains plug from the mains socket now. Do not operate the
product anymore afterwards, but take it to a specialist workshop.
Never perform any repairs on your own. Always leave them to a specialist!
18