VEVOR RLS1/4 Bedienungsanleitung Seite 9

c. the jaw is cracked, scratched, sunken or severely worn
d. other anomalies
4). It is forbidden to disassemble the tools by yourself. It is strictly forbidden to weld,
polish, drill or make other changes to the die accessories!
5). Do not put any part of the human body, such as your fingers, into the jaw ring!
6). This tool is a high-strength, heavy-duty appliance. Please strictly follow the
instructions and precautions!
CAUTION: Improper operation can lead to leaks at the joint
1). Please ensure that the press fitting specifications are the same as the jaw.
2). It should be confirmed that the jaw has been completely closed after the
pressing is completed.
3). When pressing, make sure that the jaw along with the pressing tool is properly
positioned on the flange of the fitting.
4). If the jaw cannot be completely closed when pressed, it should be sent to the
tool dealer or manufacturer for repair.
5). If the jaw connection is incorrectly squeezed, replace a new jaw and do not
continue to use it.
6). If there is a burr on the pipe joint after pressing, it should be handed over to the
tool dealer or manufacturer for inspection.
Jaw cleaning and maintenance
1) . Clean the residue accumulated in the pressing jaws in time. Cleaning the
residue can be done with a scouring pad or steel wool, but it can't be cleaned with
something harder (such as sandpaper, filet, etc.), which will accelerate the wear on
the edge of the cavity.
- 8 -