Operation; If Cold Air Is Blowing On You - Mitsubishi Electric VL-100U5-E Betriebsanleitungen

Operation

Note
- In the following cases, stop the Lossnay
and manually move the shutter knob to the
leftmost position (the closed position) to
close the shutter.
- If the outside air is cold, winds are strong,
snow or rain is falling heavily, there is heavy
fog, or fine snow is falling. (Water or snow
may infiltrate the Lossnay with the air supply,
resulting in weather damage.)
- During cleaning and inspections
1. Slide the shutter knob to the open position.
Pull cord (VL-100U -E only)
5
Note
- Make sure that the shutter knob must be
located in the open position, and then
operate the unit.
For VL-100U -E
5
2. Switching operating modes (airflow)
Pull the cord to switch from HI to LO to Off.
HI operation LO operation
(Operation indicator lights.)
For VL-100EU -E
5
2. Using the control switches.
Power switch
(On-Off)
* The switches shown above are only an
example. Operations and indicators may vary
depending on the switches installed.

If cold air is blowing on you

If cold air is blowing directly on you, flip the louver
toward you to change the direction of air flow from
vertical to horizontal.(Move manually.)
Shutter knob
Off
(Operation indicator
goes out.)
Airflow switch
(Hi-Lo fan speed)
Eng-5
Louver
Air direction (when vertical)
Air direction
(when
horizontal)
Louver
Louver