Safety Information - Leckey Easyseat Bedienungsanleitung

6 Safety information

1. Always read instructions fully
before use.
2. Users should not be left unattended at
any time whilst using Leckey equipment.
3. Only use Leckey approved components
with your product. Never modify the
product in any way. Failure to follow
instructions may put the user or carer at
risk and will invalidate the warranty on
the product.
4. If in any doubt to the continued safe
use of your Leckey product or if any
parts should fail, please cease using
the product and contact our customer
services department or your local dealer
as soon as possible.
5. Carry out all positional adjustments and
ensure they are securely fastened before
you put the user into the product.
6. When putting the child into the seat
both for positional and safety reasons,
always secure the hip strap fi rst.
7. If you have ordered an Easy Seat/
Potty Trainer with castors, we do not
recommend that children be moved over
uneven surfaces whilst in the equipment.
All due care and attention should be taken
if transporting the user in and out
of the seat.
8. If moving an easy Seat/Potty Trainer
with castors from one area to another,
the top of the back rest or the push
handle should be used to steer.
Never use the tray for this purpose.
9. Never leave the product on a
sloping surface, greater than 5 degrees.
Always remember to lock all the castors.
10.The product contains components
which could present a choking hazard to
small children. Always check that locking
knobs and bolts within the child's reach
are tightened and secure at all times.
11. Leckey products comply with fi re
safety regulations in accordance with
EN12182. However the product contains
plastic components and therefore should
be kept away from all direct sources
of heat including naked fl ames,
cigarettes, electric and gas heaters.
12. Do not place hot objects on the tray,
not greater than 40 degrees Celsius.
13. Clean the product regularly. Do not use
abrasive cleaners. Carry out maintenance
checks on a regular basis to ensure your
product is in good working condition.