Possible Cause - Vevor Std Originalanleitung

Problem
The burner will
not light.
The burner flame
goes off
immediately after
ignition.
The combustion
on the burner is
inadequate.
The burner flame
is low.
The emitter glows
uneven.
TROUBLES &SOLUTIONS

Possible Cause

The burner injector is
clogged.
There is low gas supply
pressure.
There is low gas
pressure.Ambient
temperature is less than
40℉(4 ℃).
There is not enough air.
The supply hose is bent
or twisted
There is blockage in the
burner injector.
There is blockage in the
burner injector
The base is not on a level
surface.
The gas pressure is low.
Clean the burner injector.
Call your gas supplier.
Change for a full cylinder. After
long-term use observe
whether there is frost on the
bottom of the gas cylinder.In
case of frost, it is
recommended to wait until the
frost is eliminated, or directly
replace the new gas cylinder
for alternate use.
Check the air passageways
and burners for dirt and debris,
and clean with compressed air.
Straighten the hose and
perform a leak test
Clean or replace the burner
injector.
Clean or replace the burner
injector
Place the heater on a level
surface.
Replace the cylinder with a
new cylinder.
- 15 -
Solution