Controls And Electrical Connections - Key Automation Spark02 Anleitungen Und Hinweise Zu Installation Und Einsatz

EN

2 - CONTROLS AND ELECTRICAL CONNECTIONS

The spotlight is equipped with an IP65 integrated wiring system, featuring
a jack-type male connector for power input (fig. 1a) and a jack-type female
connector for cascade parallel cabling (fig. 1b). These jack connectors are
compatibile with the wiring already integrated into some pergola lighting
systems.
The spotlight also comes with an 1,5 m additional cable (fig. 1c), to get
extra reach if needed.
Always observe the power supply polarity indicated in Fig. 2. The luminous
flux is dimmable via PWM.
Fig. 2
+ -
In the case of parallel connections (fig. 3), the maximum number of spot-
lights that can be connected is 10, and the cross-section of the backbone
wiring should not be less than 2x0.4 mm² (AWG 21).
Fig. 3
24 Vdc
6
+ -
1
MAX 10
10