Key Automation SPARK02 Anleitungen Und Hinweise Zu Installation Und Einsatz Seite 4

EN
WARNING !
The product must only be installed on metallic
surfaces. It is not suitable for direct installation on
flammable surfaces.
WARNING !
The product is not suitable for being covered with
thermally insulating material.
All installation, wiring, or maintenance operations must be carried
out with the power supply disconnected and under safe conditions.
Always comply with the declared power supply specifications. Obser-
ve the indicated polarities. Use only SELV-equivalent power supplies
with a constant regulated output voltage of 24V. If the spotlight is in-
tegrated into a larger system, ensure that its specifications are compati-
ble with all components involved, with particular attention to the characte-
ristics outlined in Chapter 1.2 (Technical Specifications) of this manual.
Incorrect
promise
Perform all wiring connections in a manner that ensures the required pro-
tection level for the installation environment. If the connections are hou-
sed within the same compartment as the product installation, ensure an
IP protection level equal to or greater than that declared for the device.
The LED module integrated into this lighting fixture is not repla-
ceable. In the event of a malfunction, replace the entire spotlight.
Key Automation S.r.l reserves the right to modify these instructions if ne-
cessary. The updated version of these instructions and/or superior ver-
sions can be found on the website: www.keyautomation.com
4
connections may
the functionality
damage the
and safety
devices and
of the system.
com-