OK. ODW 121 Gebrauchsanweisung Seite 29

Adjusting salt consumption
1. Activate the setup mode: Close the door within 60 seconds after power ON, press "Start/
6
Pause" button and hold for 5 seconds, the machine will enter setting mode which is indicated
by the alternatingly blinking indicator lights of "Spezialsalz ergänzen" (water hardness) and
"Klarspüler ergänzen" (rinse aid) "Spezialsalz ergänzen" and "Klarspüler ergänzen".
2. Adjust level of salt consumption: Press the Start/Reset button to select the proper setting
according to your local environment. Follow table below to find correct setting.
Water Hardness level
°dH
1)
0-5
6-11
12-17
18-22
23-34
35-45
3. The product will exit the setup mode automatically 5 seconds after last setting/operation of
switch.
Note:
German degree of measurement for the water hardness
1)
millimol, international unit for water hardness
2)
* factory setting
)
Contact your local water board for information on the hardness of your water supply.
IM_ODW121_150402_V04_HR.indb 29
Setting
mmol/l
2)
0-0.9 1
1.0-2.0 2
2.1-3.0 3
3.1-4.0 4 *
4.1-6.1 5
6.2-8.0 6
29
Digital display stalls
H1: Sanft 40°
H2: 60 min. Programm
H3: 60 min. Programm and Sanft 40°
H4: 90 min. Programm
H5: 90 min. Programm and Sanft 40°
H6: 90 min. Programm and 60 min. Programm
EN
2/4/15 4:23 PM