Maximum 500 NANO SINGLE Installationsanleitung Seite 7

LED/buttons
PWR
(Red)
PLC
(Green /Orange/Red)
ETH
(Green )
*1 : The "Power" LED indicator will blink in standby mode. It will get into standby
mode, if you plug the device to outlet and no Ethernet link detected after booted
and 60 second later. If you unplug the Ethernet cable, it will get into standby mode
after 60 seconds. Under standby mode, PLC and ETH LEDs will both be off.
Push Buttons (Only applicable for models with push button)
Push button functions are disabled under Standby mode.
NID/RST Button Usage:
1. Set 2 devices into same group (private network):
Step 1. Press and hold the device's "NID/RST" button for less 3 seconds at same
time. You can release the button these device would into same private network.
2. Add a new device to the existing private network:
Step 1. Plug the new device and one grouped device. Press and hold its "NID/
RST " button less 3 seconds at same time.
Step 2. The new device starts to communicate with the device from existing
private network, and tries to join this existing private network.
Step 3. If failed, please repeat Step 1 to Step 2 again.
On: Power on
Blinking: Standby mode (*1)



On: Ethernet Link detected
7
English