Maximum 500 NANO SINGLE Installationsanleitung Seite 5

• The PWR LED indicator will light on after plugging.
• You can repeat steps 1 and 2 for connecting the others.
• The PLC-ACT LED indicator starts blinking when the data communication
proceeds on Powerline.
• The ETH-ACT LED indicator starts blinking when the data communication
proceeds on Ethernet.
To share a xDSL or cable modem with Internet access service
1. Connect one powerline product to the broadband router
• Plug the powerline into an AC outlet.
• Plug the provided Ethernet cable into the RJ45 connector of the
powerline product and plug the other end of the cable into an available
Ethernet port of the Router.
2. Connect the other powerline products(s) to the PC(s) to share the Internet access
• Plug the Bridge into an AC outlet.
• Plug the provided Ethernet cable into the RJ45 connector of the powerline
product and plug the other end of the cable into Ethernet port on the PC.
As wireless AP (Access Point) Extender
1. Connect one powerline to the broadband router
• Plug the Bridge into an AC outlet.
• Plug the provided Ethernet cable into the RJ45 connector of the
powerline product and plug the other end of the cable into an available
Ethernet port of the broadband router.
2. Connect the other 500 NANO to the wireless AP.
• Plug the Bridge into an AC outlet.
• Plug the provided Ethernet cable into the RJ45 connector of the powerline prod-
uct and plug the other end of the cable into the Ethernet port on the wireless AP.
5
English