Maximum 500 NANO SINGLE Installationsanleitung Seite 4

5.
Familiarize yourself with the Powerline device connections:
• There is only one Ethernet port. This is used for the connection with PC,
xDSL/Router, Cable Modem, or Wireless AP.
6.
Limitation of the PLC device:
• To meet the safety regulation, the longest distance between powerline
carrier devices will be limited at 200 meter and for in-house use only.
More than 200 meter will cause the signal reduction or data loss.
• Always connect to the nearest source where possible and avoid exten-
sions power connectors. Every step that brings you further away from the
source (your power network) will cause signal reduction or loss.
• There are some limitations in regards to the house main installation.
Some phase jumps might not be possible or cause signal reduction or loss.
Product Installation Guide
Notice:
Do not plug the device into a power strip or surge protector because these
devices may consist of filter and impair signal. Also avoid plugging the
device right next to noisy sources such as cell phone charger, Halogen light,
Energy saving bulb, noisy desktop computer, vacuum cleaner, etc. Both
cases result in poor transmission speed. Nevertheless, you can put the
noisy source to the Pass Through's outlet. The outlet will filter out the noise
and improve the Powerline communication performance.
To install for the PC local Powerline network
• Use the supplied Category 5 Ethernet cable to connect powerline product
and your PC's Ethernet port.
• Plug the powerline product to power outlet.
4
English