Dawicontrol DC-2980 U2W Kurzanleitung Seite 21

Quick Guide
9.4 Summary of DC2980.SYS Command Line Switches
If you wish to use the Power Save function or if any problems are caused by
customised configurations, you can add the following switches to the SCSI driver.
Start the "REGEDT32" program. Display the SCSI adapter parameters by
opening HKEY_LOCAL_MACHINE, SYSTEM, CurrentControlSet, and Services in that
sequence. Then choose "DC2980" and select Device. A DriverParameter entry listing
the current settings will be displayed on the right panel. Click on DriverParameter to
open a dialog that allows you to change the parameter settings.
The following parameters are supported by Windows NT:
/PS=.. Specifies the interval (in minutes) after which inactive drives are to be
switched off.
/*SN=.. Specifies the Target-IDs for which the synchronous/asynchronous
data transfer settings of Windows' Device Manager are to be ignored,
i.e. for which control is be given to the SCSI device. Hostadapters
supplied with a SCSI setup ignore this parameter and use the setup
settings instead.
/!SN=x,..,x This parameter defines the devices that are to run in asynchronous
instead of in synchronous mode, independent of the Windows mode
setting for these devices. Hostadapters supplied with a SCSI setup
ignore this parameter and use the setup settings instead.
- 21 -