Intended Use; Scope Of Delivery; Explanation Of Symbols - Conrad Electronic Thermaltake Butterfly Bedienungsanleitung

• Always take note of the max. power consumption limits of the individual operating volt-
ages given under point 10 of these operating instructions (refer also to sticker on the
power unit).
The power unit can be destroyed through overloading. There is an additional
risk that connected consumers, e.g. motherboards, hard disks etc, may be
damaged.
• If your motherboard has the 4-pin ATX2.0 connection for +12-V voltage (e.g. can be
found on many motherboards for Intel P4 or AMD64 CPU), connect it to the corre-
sponding connection of the PC-ATX switch-mode power unit.
The port is usually used to provide a better supply to the switch-mode controls on the
motherboard (which generate the current/voltage for the CPU) and to reduce the load of
the +12V wire of the ATX current connector.
38

1. Intended Use

The ATX power unit has to be mounted and operated in a suitable PC ATX housing. There
it is used to supply PC components such as the motherboard, the hard disk, the CD-ROM
etc. with power.
The motherboard must have an ATX power connection.
No part of the product may be modified or converted.
The housing may be opened. The stickers on the product may not be damaged or
removed and not may any of the product's screws or attachments be slackened or
removed.
Use other than that described above can lead to damage to the product and may involve
additional risks such as, for example, short circuits, fire, electrical shocks etc.
Observe all the safety and mounting instructions contained in these
operating instructions.

2. Scope of delivery

• Power unit
• Mains cable
• 5.25" safety screen with speed control
• Radial ventilator (80 mm) t4o be mounted in the PC housing
• Screw set
• Operating instructions

3. Explanation of symbols

The symbol with the lightening in the triangle is used when your health is at
risk, e.g. through an electric shock
The exclamation mark in a triangle indicates to you particular risks in hand-
ling, operating and control.
The "Hand" symbol indicates special tips and operating information.
23