Instar IN-9008 Schnellinstallationsanleitung Seite 2

Content of delivery: lx Heating Element for IN-9008 Full HD, lx Quick Installation Guide
INSTAR Deutschland hereby ensures that you will not lose your warranty by installing this additional heater.
ATTENTION: Any damages caused by the user due to faulty installation are excluded from the warranty.
O Opening the camera casing
Assuming the camera hasn't been installed yet, we will first need to remove
the 4 outer screws (1 Be careful not to tear out the antenna cable
when removing the back of the casing. Untighten the fixation screw (2)
O Connecting & placement of the heater
Plug in the heater. Slide the heating element O between the metal
sleigh and the connector board. Place the temperature
top of the connector board with the metal surface facing the casing
The metal surface must not touch
INSTAR Germany - Your Specialist for IP-Cameras and Surveillance Technology
Heater for IN-9008 Full
Quick Installation
sensor O on
the boards.
HD UPGRADE PACK
Guide
Locating the heater connector
Slightly pull out the hardware sleigh. Don't pull it all out since the
motherboard is still connected to the PIR & microphone.
side you will find a labeled connector for the heater.
Finishing the installation
Connect all necessary cables and make sure they are not squeezed by
the sleigh. Tighten the fixition screw and follow the INSTAR Camera
Installation Guide on https://install.instar.com
and mount.
On the right
c152
to assemble the casing
https:// install.instar.com
www.instar.com