Installation guide for display 20002
support@pinled.de
PinLED
Page 12
Connect the included display power sup‐
ply cable with the two red wires at J17 pin
1 and 4.
Use the two include cable clamps to make
the connection at J17 pin 1 (red) and 4
(red).
Shoes the complete setting.
The original 8‐pin connector is not in
use any longer!!!
That it! Switch the machine to on.
You can use a black card board to make a
cover for the sides of the display segments
to cover the electronics.
Version 1.0
©2015 by PinLED