Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation guide for display 20002
The PinLED display set 20002 is for use in all pinball machines of all brands that comes
with a 128x 32 Dot‐matrix display. This manual covers pinballs from Bally/Williams,
Data East, SEGA/STERN and Gottlieb. For the installation you need a Philips screwdriver
and a universal plier for pressing the cable clamps.
1. Unplug the mains plug.
2. Remove the back glass of the back box and open the door behind.
3. Put the speaker panel on the playfield glass or slew it aside.
4. Remove the cables to the old display.
5. Remove the four nuts of the old display and put them by side (they are used later to
fix the new displays).
6. Remove the old display.
7. Put the new PinLED display into the mounting brackets of the speaker panel. Notice
the right direction of the display. The power connector faces to your direction.
8. Fix the display with the four nuts.
9. Reconnect the flat cable.
10.
The PinLED display has its own power supply. This needs a power input of 9‐
10VAC or 12‐14VDC. This will be described in the following steps.
The original 8‐pin connector is not in use any longer. You can put it by side
and fix it to the cable harness with a cable tie. THE DIFFERENT VOLTAGES
THAT IT SUPPLY ARE NOT LONGER NEEDED AND THEY CANNOT SUPPLY
THE PINLED DISPLAY.
•
Bally/Williams with original installed power driver
supply the PinLED display is to use the 9VAC winding of the transformer in Bal‐
ly/Williams pinballs. The 9VAC will enter the power driver board at connector
J101 pin 1 (red) and pin 2 (red). With the aid of two cable clamps connect the
included power cable to both red cables, which reach the board at J101 pin 1 and
2. The sequence does not matter because it is an AC supply voltage. At last con‐
nect the 4‐pin connector to the display.
• Bally/Williams with PinLED power driver board: You can use connector J100
if you use the PinLED power driver board. This connector will supply the 9VAC
too. You have to add a 4‐pin connector to the second end (this will not be sup‐
plied with the display) and connect it to J100. At last connect the 4‐pin connector
to the display.
•
Data
East: The best way to supply the PinLED display is to use the unregulated
12VDC at Data East pinballs. You will find the unregulated 12VDC on the sound‐
board at connector CN2. The voltage will enter the board on pin 2 (black) and
pin 6 (grey/white). With the aid of two cable clamps connect the included pow‐
er cable to the black and grey/white wires. The sequence does not matter be‐
cause the PinLED display includes a rectifier. At last connect the 4‐pin connector
to the display.
• SEGA/STERN: The best way to supply the PinLED display is to use the 9VAC
winding of the transformer in Data East pinballs. The 9VAC will enter the power
driver board at connector J17 Pin 1 (red) and Pin 4 (red). With the aid of two
cable clamps connect the included power cable to both red cables, which reach
support@pinled.de
PinLED
Installation
!! Attention !!
Page 2
Version 1.0
board: The best way to
©2015 by PinLED
Werbung
