PinLED Display 20002 Einbauanleitung Seite 19

Installation guide for display 20002
support@pinled.de
PinLED
Install the new PinLED display and re‐
mount the five mounting screws. Connect
the flat cable and the included display
power cable.
Put the metal cover plate back on and fix it
with the two screws and the four spacers.
Reinstall the display driver board and fix it
with the four Philips screws. Reconnect
the flat cable and the power supply cable.
The original power supply connector is
not in use any longer. Store it in the back
panel and fix it to the cable harness with a
cable tie.
You will find the unregulated 12VDC at
connector CN2 on the soundboard.
Page 7
Version 1.0
©2015 by PinLED