Using The Product As A Stool; Using The Product As A Creeper; Maintenance - Parkside Performance Hg12903 Bedienungsanleitung

Small part box
1. Fix the small part box
by screwing the clamping nut
clockwise shown in (fig. E).
Storage Tray
1. Fix the storage tray holder
frame by screwing the 2 clamping nuts
clockwise shown in fig. F1.
[ 11 ]
2. Insert the screw
tray to the female part of the storage
[ 13 ]
tray holder . Secure the part by
[ 14 ]
screwing clockwise. (fig. F1)
3. To extent the holder horizontally or
vertically, press the click and pull the
holder until the click is fixed to the outer
hole. (fig. F2)
4. To shorten the holder horizontally or
vertically, press the click and push
the holder until the click is fixed to the
inner. hole. (fig. F3)
LED Light
1. Fix the LED light holder
frame by screwing the clamping nut
clockwise shown in fig. G.
Starting the LED Light
1. Turn the LED cover anticlockwise to
open (fig. H1) and remove the plastic
insulator (fig. H2).
2. Turn the LED cover back in clockwise to
finish the assembly and push the button
to turn on the LED light (fig. H3).
Changing LED Battery
1. Turn the LED cover anticlockwise to
open (fig. I1).
2. Turn the battery compartment cover
anticlockwise by using the two tips on
the handle of the wrench
it from the LED body (fig. I2).
3. Remove the battery compartment from
the LED body (fig. I3).
4. Push and remove the old batteries out
of the battery compartment from the
negative pole (-) (fig. I4).
5. Insert the new batteries into the battery
compartment. Ensure the batteries are
in correct polarity ( + and - ) (fig. I5).
16 GB
to the frame
12 ] [
[ 11 ]
to the
14 ] [
through the storage
16 ] [
to the
[ 15 ]
to remove
[ 9 ]
6. Place the battery compartment back
into the LED light (fig. I5).
Note: Check the diagram on the battery
compartment to ensure correct polarity,
with the positive polarity pointing out.
7. Screw the battery compartment cover
clockwise by using the two tips on the
handle of the wrench to secure the
battery compartment (fig. I5).
8. Screw the LED cover back in clockwise
to finish the assembly (fig. I6).
˜ Use
You can use the product as a creeper or
stool.
˜ Using the product as a stool
To use the product as a stool, follow the
steps below:
1. Pull the safety pin
frame
3 ] [
letting go.
2. Fold the central frame
11 ] [
and let go of the safety pin so that it
engages with the safety hook
middle frame (fig. J).
3. Fold the upper frame
horizontal position (fig. K).
˜ Using the product as a
creeper
To use the product as a creeper, follow the
steps for "Using the product as a stool",
but in reverse order.
˜ Maintenance
Regularly check that all screw connections
are tight and retighten them if necessary.
Do not immerse the LED light into water.
Liquid can damage the LED light.
out of the lower
3a ] [
as far as possible without
upwards
2 ] [
into a
1 ] [
on the
2b ] [