Herunterladen Diese Seite drucken
Verfügbare Sprachen

Verfügbare Sprachen

TBLE-Ø@5
TAMIYA
BRUSHLESS
ELECTRONIC
Thank you for purchasing
the Tamiya
(Sensored). This electronic speed controller is designated for use
with the Tamiya Brushless Motor 01 (Sensored) series, and also
Sport-Tuned
Motors and brushed
refully and fully understand instructions prior to use. Make sure to
read the following safety precautions as breakage and accidents
due to improper use will void your warranty.
*Using servos with a current exceeding 1.5Amay cause damage
to the ESC.
WARNING
Pay close attention to the following safety precautions as improper
use can destroy the product and void your warranty or lead to proper-
ty damage and personal injuries.
'This
speed controller is intended for use with R/C models that
operate
on the ground.
Do not use with other models.
'Connect
receiver to ESC and servos securely. Connectors may
become loose due to vibrations while running.
'Never operate any RIC model in electrical storms.
'Avoid running in rain or through surface water. Water in the receiver
may cause loss of control.
'Disconnect
and remove battery when car is not being used. If left
connected the car may run out of control, causing damage or injury.
'Keep receiver, battery and model etc. out Ofreach of small children.
(Part names)
Battery connector
*For Tamiya Battery Pack
Receiver
switch
Receiver
connector
*Connect
to 2 (CH.2) on receiver.
Black
'Cut
off the tab when connecting
to
SANWA
or
JR
receiver.
Note
direction and polarity when connec-
ting.
(LED Flashing Pattern)
Setup confirmation
When the receiver
is switched
on, the LED will
show the current settings with the number and
length of its flashes to enable checking of reverse,
low voltage protection and motor mode settings.
As all 3 settings are shown by one LED, please
refer to the diagrams.
Reverse Function Low Voltage Protection S etup
ON
ON
OFF
OFF
SPEED CONTROLLER
Brushless
ESC 02
motors over 25 turns. Read ca-
*Always turnON transmitter first,thenreceiver. Always t urnOFF receiver first,then transmitter.
Oppositeordermayleadto anoutof controlR/Ccarandanunexpected accident.
OConnection
Tnxzu:æaras
Blue
Yellow
Orange
LED
Set button
Motor Setting
Brushless
Mode
Orange
Brushed
Mode
LED
*
Singleflash
Double flash
Longsingle flash
Longdouble flash
oe (SENSO*D)
Specifications
ESC: Forward
/ Brake / Reverse
Max. Continuous
Current:
60A
Input Voltage: 6.6-7.2V
Output: Forward —100%
Dimensions:
45x34x25mm
Weight: 50.8g
Compatible
Motors: TBLM-OIS
(Sensored), Sport-Tuned Motor,motorsover25turns
Receiver Output Voltage: 6V/I .5A
CAUTION
(DMake sure thepolarity i scorrect when c onnecting
and motor to prevent damage to ESCand receiver.
OContinuous running m ay loosen b attery c onnection. Battery, motor
andESC become e xtremely hotduring orafteroperation a ndcan
cause
burns
if touched.
C)Never short c ircuit battery o rmotor cables a sit may d amage the
RIC
unit.
(DThisspeed controller is not waterproof.
ODO notdisassemble ormodify t heESC. This ESC isonly foruse with
Tamiya batteries and motors. Use Of o ther products may d amage the
RIC unit.
Neverrunan R/Cmodelonroadsor streets,or in crowdedareas.
o
C)Never connect toabrushed m otor w hen ESC isinbrushless mode
and vice versa, as this may damage the ESC.
OAvoid strong shocks o rimpacts t hatmay damage theESC.
Sensor
cable
Motor
connector
(Brushless
motors) OConnection
= *Motor.
Blue
= *Motor:
Yellow
= *Motor.
Orange
(NOTICE) ThisESC isnotequipped w ithcooling fan,andif paired
withTBLM-OIS Motor ( 10.5T) foroff-road driving use, t heheat p rotec-
tionfunction may frequently stopESC operation. Inthatcase, p lease
adjust t hegear r atioapproximately
chassis).
'If receiver isturnedonwhile transmitter isoff,LED willflash.
If motor is connected an alarm will also sound. (Alarmwill not
sound iftheFail S afeFunction o f,your t ransmitter issetto ON.)
LED
'PleasenotethatpartssuchasESC, m otor, b attery, and
wiresemitnoisedueto largeamounts of electriccurrent.
Green
Putting thereceiver a ndantenna near suchdevices maylead
to interference causing lossof control. T hereceiver a nd
antenna must not touch the ESC.Theantenna must not cross
over with cables from the ESC. Cables should be tied up.
Carbonor metalchassismayalsotransfer interference.
ITEM 45057
TAMIYA
Reverse —50%
series o fTamiya Brushless
Motors
abattery p ack
* Motor
:
Orange
*Motor
:
Yellow
*Motor
:
Blue
(Brushed motors)
= *Motor: Minus (-)
Blue
Yellow
*Motor: Plus(+)
Orange = *Not used.
to 10:1 (4WD chassis) or9:1(2WD
45057TBLE-02S (11054660-002)
loading

Inhaltszusammenfassung für Tamiya TBLE-025

  • Seite 1 ODO notdisassemble ormodify t heESC. This ESC isonly foruse with 'Avoid running in rain or through surface water. Water in the receiver Tamiya batteries and motors. Use Of o ther products may d amage the may cause loss of control.
  • Seite 2 Also check if reverse function has been turned off. move backward. Conta your l ocal Tamiya d ealer f oranyquestions regarding thisspeed controller including parts, defectsandrepairs. *Sen theproduct withdetailed description Ofthemalfunction to Tamiya C ustomer Service f or...
  • Seite 3 Bauen Sie den Fahrtregler nicht auseinander und verändern Sie ihn 'Betreiben Sie niemals ein RIC Modell während eines Gewitters. nicht. Der Fahrtregler ist nur für die Nutzung von Tamiya Akkus und 'Vermeiden Sie die Nutzung im Regen OderDurchfahrtendurch Motoren vorgesehen. Die Nutzung anderer Produkte kann die Fem- Wasser.Wasser im Empfänger kann zu Verlust der Kontrolle führen.
  • Seite 4 LED Anzeige istnormal d emWechseln desSenders durchführen. Überprüfen 0b dieRückwärtsfunktion ein- fährt nicht geschaltet ist. rückwärts WendenSie sich an Ihrenörtlichen Tamiya-Händlerbezüglich aller Fragen,die diesenFahrreglerbetref- fen, einschließlich Teilen, Defekten und Reparaturen. aaTAMIY.A *Senden Sie das Produkt als Reparatur-Auftragmit einer genauen Beschreibungdes Fehlers an den Tamiya Kundendienst (Nur gültig innerhalb...
  • Seite 5 Caractéristiques (Sensored) Cevariateurde vitesseélectroniqueest conqupour Fonctions : Avant / Frein / Arriöre une utilisation avec les moteurs brushless Tamiya 01 (avec cap- Courant maxi continu : 60A teur) ainsi que Ies moteurs Sport Tuned et Ies moteurs å charbons Tension d'alimentation : 6,6-7,2V de 25 tours au moins.
  • Seite 6 étéchangé. Vérifier s i la fonction marche ments arriéren'a pasété désactivée. de marche arriöre Contact votre revendeu local Tamiya pour t outes q uestions relatives aux Piéces déta- chées et réparations. *Envo leprodu c une descripti détaillée...

Diese Anleitung auch für:

45057