Tesla IR200R Bedienungsanleitung Seite 4

CAUTIONS OF THE FIRST USE
1. There is little liquid in the iron due to testing, the iron
may slightly release steam when first turned on. After a
short time this will stop.
2. Before using for the fist time, remove any sticker or
protective foil from the soleplate. Clean the soleplate
with a soft cloth.
COMPONENT NAME
F
K
D
B
A
Filling with Water
Make sure iron is unplugged and the thermostat dial is in
the MIN position. Place iron on the heel rest, tilt forward
approximately 45 angle and pour water into the water-filling
opening to the MAX position of the water tank.
Vertical Steam
" Burst of Steam" can also be applied when holding the iron
in vertical position, this is useful for removing creases from
hanging clothes, curtains, etc.
Dry Ironing
1. Set the steam selector to position O(=No Steam)
2. As per washing label of various clothes, set the correct
ironing temperature to begin a ironing.
Steam Ironing
1. Fill water in the iron as per the water-filling methods.
2. Plug the appliance in the socket.
3. If only set thermostat knob to MAX position as per the
temperature indicator, steam iron will be available,
otherwise water may leak from the soleplate.
4. It indicates that the temperature has been ready until the
indicator light goes off.
4
G
E
L
3. Keep the soleplate smooth: avoid hard contact with
metal objects.
A Soleplate
H
B
C Water tank
D Water refill lid
I
E
F
J
G Handle
H Flexible cord protector
I
J
K
L
C
5. Set the steam selector correctly, increase steam output
by pushing the steam selector back and decrease steam
output by forward.
CAUTION!
Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use
the steam iron, otherwise it will damage the finish of surface.
Burst of Steam
This function works well for tough wrinkles and heavy fabrics.
By pressing "Burst of Steam" button,an intense burst of steam
is emitted from the soleplate, this can be very useful when
removing stubborn creases. The shot of steam facility can
be used only while ironing with high ironing temperature.
For optimal result, there should be 5 seconds rest between
presses of the steam button. To prevent leaking water from
the soleplate does not press the steam button continuously
for more than 5 seconds.. Also allow at least one minute
interval before applying this burst of steam function.
Spraying Methods
At any temperature by pressing the spray button a couple
of times, the laundry can be damped down. Ensure that
there is enough water in the water tank.
Water spray nozzle
Spray button
Steam button
Rear cover
Power indicator light
Steam adjustment knob
Temperature adjustment knob